Eagle Electronics FISHEASY 240 User Manual

Page 17

the metal bracket. This position sets the transducer's coarse angle ad-
justment for a 14

° transom. Most outboard and stern-drive transoms

have a 14

° angle.

Align plastic ratchets in bracket.

2. Aligning the transducer on the transom. Slide the transducer

between the two ratchets. Temporarily slide the bolt though the trans-

ducer assembly and hold it against the transom. Looking at the trans-

ducer from the side, check to see if it will adjust so that its face is paral-

lel to the ground. If it does, then the "A" position is correct for your

hull.
If the transducer's face isn't parallel with the ground, remove the

transducer and ratchets from the bracket. Place the ratchets into the

holes in the bracket with the letter "B" aligned with the dot stamped in

the bracket.
Reassemble the transducer and bracket and place them against the

transom. Again, check to see if you can move the transducer so it's par-

allel with the ground. If you can, then go to step 3. If it doesn't, repeat

step 2, but use a different alignment letter until you can place the

transducer on the transom correctly.

Dot