Eagle Electronics FISHEASY 240 User Manual

Page 15

How low should you go?
For most situations, you should install your Skimmer transducer so

that its centerline is level with the bottom of the boat hull. This will

usually give you the best combination of smooth water flow and protec-

tion from bangs and bumps.

Align transducer centerline with hull bottom.

However, there are times when you may need to adjust the transducer

slightly higher or lower. (The slots in the mounting brackets allow you

to loosen the screws and slide the transducer up or down.) If you fre-

quently lose bottom signal lock while running at high speed, the trans-

ducer may be coming out of the water as you cross waves or wakes.

Move the transducer a little lower to help prevent this.
If you cruise or fish around lots of structure and cover, your transducer

may be frequently kicking up from object strikes. If you wish, you may

move the transducer a little higher for more protection.

There are two extremes you should avoid. Never let the edge of the

mounting bracket extend below the bottom of the hull. Never let the

bottom – the face – of the transducer rise above the bottom of the hull.
Shoot-Thru-Hull vs. Transom Mounting
In a shoot-thru-hull installation, the transducer is bonded to the inside

of the hull with epoxy. The sonar "ping" signal actually passes through

the hull and into the water. This differs from a bolt-thru-hull installa-

Transom

Hull bottom

Transducer
centerline