Eagle Electronics FISHEASY 240 User Manual

Page 25

NOTE:

Periodically wash the transducer's face with soap and water to re-

move any oil film. Oil and dirt on the face will reduce the sensitiv-

ity or may even prevent operation.

Shoot-Thru-Hull Preparation

Hulls With Flotation Materials

The transducer installation inside a fiberglass hull must be in an area

that does not have air bubbles in the resin or separated fiberglass lay-

ers. The sonar signal must pass through solid fiberglass. A successful

transducer installation can be made on hulls with flotation materials

(such as plywood, balsa wood or foam) between layers of fiberglass if

the material is removed from the chosen area. See the figure below.
WARNING:

Do not remove any material from your inner hull unless
you know the hull's composition. Careless grinding or
cutting on your hull can result in damage that could
sink your boat. Contact your boat dealer or manufac-
turer to confirm your hull specifications.

Epoxy the transducer to a solid portion of the hull.

Inner hull

Epoxy to hull first

Outer hull

Flotation material

Fill with resin