beautypg.com

Figure 3-1. epim-t cross-over switch, Insert the rj45 connector on the twisted pair s, Check that the epim’s lnk led is on. if the led – Enterasys Networks BRIM-E6 User Manual

Page 20: A. check that the 10base-t device at the other end, B. verify that the rj45 connector on the twisted p, C. check the cable for continuity, D. check that the twisted pair connection meets db, E. check that the crossover switch is in the corre

Figure 3-1. epim-t cross-over switch, Insert the rj45 connector on the twisted pair s, Check that the epim’s lnk led is on. if the led | A. check that the 10base-t device at the other end, B. verify that the rj45 connector on the twisted p, C. check the cable for continuity, D. check that the twisted pair connection meets db, E. check that the crossover switch is in the corre | Enterasys Networks BRIM-E6 User Manual | Page 20 / 41 Figure 3-1. epim-t cross-over switch, Insert the rj45 connector on the twisted pair s, Check that the epim’s lnk led is on. if the led | A. check that the 10base-t device at the other end, B. verify that the rj45 connector on the twisted p, C. check the cable for continuity, D. check that the twisted pair connection meets db, E. check that the crossover switch is in the corre | Enterasys Networks BRIM-E6 User Manual | Page 20 / 41
See also other documents in the category Enterasys Networks Hardware: