Vivotek S Series IZ9361-EH 1080p Outdoor Network Bullet Camera with Heater - Manual (Page 437)

VIVOTEK
User's Manual - 437
© 2020 VIVOTEK INC. All Right Reserved
282
Syntax:
http://
/cgi-bin/admin/connect_ap.cgi
PARAMETER
VALUE DESCRIPTION
N/A N/A Apply the wireless settings and connect to AP.
8.31 Get Wireless Information (capability_network_wireless >
0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://
/cgi-bin/admin/getwirelessinfo.cgi
PARAMETER
VALUE DESCRIPTION
N/A N/A Get wireless information. Camera will return following
information.
1. Wireless channel
2. Link quality
3. Signal level
4. Noise level
5. SNR
6. TX Rate
7. RX Rate
8.32 Get Wireless Signal Strength (capability_network_wireless
> 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://
/cgi-bin/admin/getwlsignalstrength.cgi
© 2020 VIVOTEK INC. All Right Reserved
283
PARAMETER
VALUE DESCRIPTION
N/A N/A Get wireless signal strength.
8.33 WPS Transaction (capability_network_wireless > 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://
/cgi-bin/admin/start_wps.cgi
PARAMETER
VALUE DESCRIPTION
N/A N/A Start WPS transaction.
8.34 Peripheral Control (capability_peripheral_c<0~(n-1)>_
devicecontrol > 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
(for control API)
http:///cgi-bin/admin/peripheral.cgi?channel=&operation=set
[&washer_mode=] – Set washer mode
[&washer_status=] – Set washer status
[&washer_dwelltime=] – Set washer clean time
[&heater_status=] – Set heater status
Example:
http://myserver/cgi-bin/admin/peripheral.cgi?channel=0&operation=set&washer_mode=wiper&
washer_status=on
Response:
HTTP/1.0 200 OK\r\n
Cache-control: no-cache\r\n
Pragma: no-cache\r\n
\r\n