Eclipse - Fujitsu Ten CD5444 - Manual (Page 28)

28
ESN security operating procedure
[FUNC] button
Buttons [1] to [4]
The security function can be canceled when the security code
that has been recorded with the deck is entered and verified.
Canceling the security function can be done by entering the
security code into the deck, or by using the Memory Stick.
Canceling the security function by entering the security code
Check that the Power is OFF.
Press and hold button [1], then the [FUNC] button, and
hold both for more than one second.
A [SEC] message appears, then in two seconds it will
change the [- - - -] security code input display.
Input a security code by pressing buttons [1] to [4].
Enter a four-digit security code using digits 0 to 9, A to F.
The number (shown on the display) changes in ascending
order between 0 and 9, A and F each time the button is
pressed. Each button number (1 to 4) corresponds to each
digit (first to forth) of the security code.
Press the [FUNC] button.
If a security code is entered and the deck verifies that it is
correct, [CANCEL] will appear on the display and the
security function will be canceled.
4
3
2
1
How to cancel the Memory Stick security
ATTENTION
If the security code that is entered does not match the code that
is recorded by the deck, [ERR] will appear on the display for two
seconds and operation will continue as normal without the
security function being canceled.