Call waiting in-call menu, Dealing with multiple calls – Ericsson SATELLITE R290 User Manual

Page 54

R290 User’s Guide

you are not available,

to cancel call wait incoming calls when the

phone is switched off.

5. Select the basic service group for which the call wait is to be

cancelled. The display will show:

6. Press

for All Calls,

for Voice Only,

for Data Only or

for Fax

Only.

The message ‘Please Wait’ being shown on the display. When the
network has acknowledged the request, a message ‘Request Accepted’
will appear in the display to confirm that the call waiting option has been
cancelled. The phone will then return to stand-by.

Call Waiting In-Call Menu

When you are in a call, you may select the Call Waiting In-Call Menu to
deal with the waiting call by pressing

SOFT LEFT

. The display will be:

1. Press either

YES

to end the active call and accept the waiting

call.

2. Press

to place the active call on hold and accept the waiting call (if

you are subscribed to this option and you do not have a call on hold).
If you already have a call on hold this will bring up the message ‘Call
Already on Hold’ before reverting to the in-call display.

3. Press

to reject the waiting call and continue with the active call.

If you do not wish to accept the waiting call but you have not explicitly
rejected it, it will time-out and go away.

Dealing with Multiple Calls

Placing a Second Call and holding the Current Call

If you are engaged in a call and wish to make or accept a second call
without losing the original call, enter the number you wish to dial and
press

YES

at any time. If the network accepts the request, The number

which you entered will be dialled and the current call will be put on hold.
The phone will display the message ‘Call On Hold’, to remind you that
your original call is still held.

To terminate both the active and held calls, press

. Any waiting call

will not be affected

Receiving/placing a Third Call

If you already have a call on hold and you receive a third call, you will be
notified of this call in the same manner as before. You are able to accept
or reject it from the Call Waiting In-Call Menu.

You will not be able to select ‘Hld+Accept’ from the menu. If you
attempt to select this option, the message ‘Call Already On Hold’ will be
given before reverting to the in-call display. If you wish to accept the new
call, you will need to end the current call first.

If you want to make an outgoing call when you are currently involved in
two calls, you must first end one of the current calls.

Switching between Active Call and Call on Hold

When you are dealing with two calls, one active and another on hold, you
can switch between them or end either one by using the Call Hold In-Call
Menu.