Copying physical fader assignment, Fader reverse (0–255/255–0), Resetting the system – CHAUVET DJ Obey 70 Universal DMX-512 Controller User Manual
Page 13: Programming, Entering program mode, Exiting program mode, Creating a scene
Obey 70 User Manual Rev. 7
Page
13
of
69
Copying Physical
Fader Assignment
This process will copy the physical fader assignment from one fixture into another.
1. Press
and
. This will enter the physical fader
assignment mode.
2. Press & hold the fixture button that contains the desired physical fader assignment.
3. While still holding the previous fixture button, press & hold the fixture that you want to copy
into.
4. While still holding the two fixture buttons above, press & hold
.
5. While still holding all three buttons down, release the fixture selected in step # 2 above.
6. While still holding down
, release the fixture selected in step # 3 above.
7. Release
.
8. All fixture LEDs will flash.
9. Press
and
two times to exit physical fader
assignment mode.
This will not copy the fader-reverse setting(s).
Fader Reverse
(0–255/255–0)
This function will allow you to reverse the DMX output of the physical fader(s).
1. Press
and
two times. This will enter the fader
reverse assignment mode.
2. Select one of the fixtures:
(this will be the fixture that you want to modify
the channels for).
3. Move the
fader to select the physical slider (control channel).
4. Move the
fader to activate/deactivate this function.
5. Press
to save the setting.
6. Repeat steps 3–5 until all of the faders have been assigned for the fixture.
7. Press
and
one time to exit fader reverse
assignment mode.
Resetting the
System
Use this function to revert all settings and scenes back to the state they were in
when the product left the factory.
1. Turn off the unit.
2. Press and hold
and
.
3. Turn on power to the unit (while still holding
and
).
4. All LEDs will blink to indicate a successful reset.
This will erase all scenes, chases, and other settings! This process may take
up to 30 seconds to complete.
4. Programming
Entering Program
Mode
No programming may be done on the Obey 70 without first entering program mode.
You will find references to this process in many other sections of this user manual.
Press and hold
for three seconds to exit program mode.
1. Turn on the controller.
2. Press and hold
for three seconds.
3. When the LED displays Program LED lights, you have entered program mode.
Exiting Program
Mode
You will find references to this process in many other sections of this user manual.
1. While currently in program mode, press and hold
for three seconds.
2. When the LED display Program LED turns off, you have exited program mode.
Creating a Scene
Use this function to create a static look on stage.
1. Turn on the controller.
2. Enter program mode.
3. Select one or more fixtures.
4. Using the 8 sliders, modify the value of the desired channel(s).
5. When the desired look has been achieved, press
.
6. Use
to select a desired bank (30 possible) to save the scene to.
7. Once you have navigated to the desired bank, press the
(1–8) to save the
scene directly to.
8. All LEDs will flash to indicate that the scene has been saved.
9. Repeat steps 3–8 until you are finished programming all scenes.
10. Exit program mode.
You may select more than one fixture at a time. If you do so, you will not have
separate control over each of them. You may program multiple fixtures into the
same scene.
Use PAGE A/B to switch between the 2 pages for the selected fixture.