Signal output, Physical fader assignment, Joystick assignment – CHAUVET DJ Obey 70 Universal DMX-512 Controller User Manual
Page 12
Page
12
of
69
Obey 70 User Manual Rev. 7
Signal Output
In order to use this controller with multiple fixtures, you must daisy chain from the
output of the Obey 70, using DMX cables to link from one fixture to another.
Physical Fader
Assignment
Use this feature to combine or unify fixture control attributes for different fixtures. For
example; if you are controlling 4 moving mirrors and 4 moving yokes, the color, gobo,
and dimmer channels may not line up ideally on the physical faders. Use this
function to reassign these channels to faders 1, 2, and 3:
1. Press
and
. This will enter the physical fader
assignment mode.
2. Select one of the fixtures:
3. Move the
fader to select the physical slider (control channel).
4. Move the
fader to select the DMX channel.
5. Press
to save the setting.
6. Repeat steps 3–5 until all of the faders have been assigned for the fixture.
7. Press
and
two times to exit physical fader
assignment mode.
Reset the fader assignment back to the original, factory settings by performing
a soft reset. Please see the section “Resetting the System” for detailed
instructions on this procedure.
The joystick will be displayed as [SLIDERT1/SLIDERP1] for Page A, and
[SLIDERT2/SLIDERP2] for Page B.
The joystick is pre assigned to channels 15/16 (Page A) and 31/32 (Page B).
When moving channels, you must relocate the previously addressed channel
to a new location. For example: when moving channel 12 to channel 1, channel
1 must be relocated to a new channel.
Joystick
Assignment
The joystick is designed for moving head & scanning mirror products.
1. Press
and
. This will enter the physical fader
assignment mode.
2. Select one of the products:
(this will be the fixture that you want to
modify the channels for).
3. Move the
fader to select the pan control
[SLIDERP1/1]
.
4. Move the
fader to select the DMX channel to assign it to.
5. Press
to save the setting.
6. Repeat steps 3-5 for the tilt
[SLIDERT1/2]
.
7. Press
and
two times to exit physical fader
assignment mode.
When assigning the joystick to a channel (for example, channel two), you must
also relocate channel two to a new location.