Enterasys Networks Enterasys SecureStack B2 B2G124-24 - Manual (Page 17)

SecureStack B2 Installation Guide xv
About This Guide
This guide provides an overview, installation and troubleshooting instructions, and
specifications for the Enterasys
®
SecureStack B2G124‐24, B2G124‐48, and B2H124‐48
stackable Ethernet switches.
For information about the Command Line Interface (CLI) set of commands used to
configure and manage the switches, refer to the Enterasys Networks
®
SecureStack B2
Configuration Guide.
Who Should Use This Guide
This guide is intended for a network administrator responsible for installing and setting
up the stackable switches.
Note: In this guide, the following terms are used:
• Switch refers to all three switches (B2G124-24, B2G124-48, and B2H124-48 ) unless
otherwise noted.
• MGBIC (Mini-Gigabit Interface Card) refers to optional small form pluggable (SFP)
interface modules that plug into the fixed front panel MGBIC slots.
Important Notice
Depending on the firmware version used in the B2G124-24, B2G124-48, and B2H124-48 switches,
some features described in this document may not be supported. Refer to the Release Notes
shipped with the switch to determine which features are supported.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.