Front panel features, Troubleshooting — skew delay compensation, Appendix a • reference information – Extron Electronics VersaTools MTP Series User Manual
Page 18: Appendix a • specifications, Part numbers, And accessories, Appendix a, Reference information
VersaTools
®
MTP Series • Operation
Operation
VersaTools
®
MTP Series
A
Appendix A
Reference Information
Specifications
Part Numbers
3-2
Front Panel Features
SHARP
C GAIN
Y GAIN
SHARP
GAIN
MTP R S-video Receiver
Front Panel
MTP R Composite Video
Receiver Front Panel
2
3
3
1
2
3
1
Figure 3-1 — MTP receiver front panels
1
Power LED —
When lit, this LED indicates power is applied to
the MTP.
2
Sharpness
— Adjusts the output image sharpness for long cable
runs.
3
Gain control
— Adjusts the brightness of the output image to
compensate for long cable runs.
S-video receivers
— There are separate controls for luminance
(Y) and chrominance (C) on S-video MTP receivers. If the
chrominance setting on the MTP receiver’s S-video output is too
low, the image may appear in monochrome. Adjust the S-video
gain until color appears.
Composite video receivers
— There is only one gain control on
composite video MTP receivers.
All control knobs are removable to limit access if desired.
Troubleshooting — Skew Delay Compensation
CAT 5 TP cable can cause registration errors (in which
luminance leads or lags chrominance) between the Y and C
video signals on S-video transmitter/receiver pairs. Try using
the following methods to minimize or eliminate pair skew:
•
Switch to Extron’s Enhanced Skew-Free A/V UTP cable.
•
Add an S-video-to-BNC adapter and a skew
compensation cable equal to the length of pair skew to the
receiver’s output.
•
Install an S-video-to-BNC adapter and an SEQ 100 BNC
Skew Equalizer on the receiver’s video output and adjust
the skew for the leading video image.