Extron Electronics VersaTools MTP Series - Manual (Page 17)

VersaTools ® MTP Series • Installation
Installation, cont’d
VersaTools ® MTP Series
3
Chapter Three
Operation
Front Panel Features
Troubleshooting — Skew Delay Compensation
10 Captive screw audio connector (MTP R SV A, MTP R AV) —
Connect a balanced or unbalanced audio device, such as an
audio amplifier to this 3.5 mm, 5-pole captive screw connector.
See figure 2-21 to properly wire the output connector.
Unbalanced Stereo Output Balanced Stereo Output
LR
Do not tin the wires!
Ring
Sleeve(s)
Tip
Tip
Ring
Sleeve(s)
Tip
Tip
NO GROUND HERE.
NO GROUND HERE.
Figure 2-21 — Captive screw connector wiring for
audio output
Some receivers do not have audio connections.
CAUTION Connect the sleeve to ground (Gnd). Connecting
the sleeve to a negative (-) terminal will damage the
audio output circuits.
CAUTION The length of the exposed (stripped) portion of the
copper wires is important. The ideal length is
3/16" (5 mm)
. Longer bare wires can short
together. Shorter bare wires are not as secure in the
direct insertion connectors and could be pulled out.
11 RCA audio connectors (RCA models) — Connect a stereo audio
device to these L(eft) and R(ight) RCA connectors.
2-20