Extron Electronics VersaTools MTP Series - Manual (Page 12)

VersaTools ® MTP Series • Installation VersaTools ® MTP Series • Installation
Installation, cont’d
d . Align the mounting screws with the slots in the
brackets and place the MTP against the surface, with
the screws through the bracket slots.
e . Slide the MTP slightly forward or back, then tighten
all four screws to secure the MTP in place.
4 . For projector mounting , secure the MTP to a projector
mount by inserting the mounting bolt through the
bracket’s slotted hole.
Frame mounting (AAP models)
The AAP-mountable transmitters (MTP T SVA AAP and
MTP T AV AAP) can be mounted to any Extron AAP mounting
frame that accepts a double space (double height) AAP module.
See “AAP accessories” in the appendix for a partial list of AAP
devices.
The rear panel MTP connections will be inaccessible
after installation. Make all connections (see “Transmitter/
receiver throughput connections”, page 2-15) and test
the twisted pair system (apply a video source and observe
that transmitted video is displayed satisfactorily) before
installing the panel-mounted transmitter.
Install an MTP transmitter in an AAP frame as follows (figure 2-11):
MTP T AV AAP
AAP 102
AAP 102
AU DIO IN
VIDEO IN L
R MTP T AV AAP
Figure 2-11 — AAP mounting an MTP transmitter
1 . If necessary, remove the AAP frame from the device in
which it is installed.
Rack mounting instructions
On the standard rack shelf, the MTP mounts in one of eight
locations to the rear of the rack or in one of eight locations to the
front of the rack.
1 . Remove the feet from the bottom of the MTP, if installed.
2 . Mount the MTP using two 4-40 x 3/16" screws in opposite
(diagonal) corners to secure the MTP to the shelf.
3 . Install blank panel(s) or other unit(s) to the rack shelf.
Furniture or projector mounting
(all except AAP models)
Use the optional mounting kit (furniture, part #70-212-01, or
projector, part #70-217-01) to mount the MTP as follows:
1 . Remove the feet from the bottom of the MTP, if installed.
2 . Attach the mounting brackets to the MTP with the
machine screws provided (figure 2-10).
Under Desk Mounting Projector Mounting
Ceiling
Projector
Projector
Mounting
Bracket
Mounting
Bolt
Figure 2-10 — Desk and projector mounting the MTPs
3 . For furniture mounting —
a . Hold the MTP with the attached brackets against the
underside of the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
b . Drill 3/32" (2 mm) diameter pilot holes, 1/4"
(6.3 mm) deep in the mounting surface at the marked
screw locations.
c . Insert #8 wood screws into the four pilot holes.
Tighten each screw into the mounting surface until
just less than 1/4" of the screw head protrudes.
2-11 2-10