NEC E558 55" Class 4K UHD Commercial LED TV - Manual (Page 33)

English - 30
HDMI-CEC Command
Connect an HDMI-CEC compatible device to the HDMI terminal.
OSD menu HDMI-CEC
command name
Explanation Setting
CEC
(Consumer
Electronics
Control)
One Touch Play When an HDMI-CEC compatible deviceis
turned on, the monitor connected to
the device with an HDMI cable also
automatically turns on.
After the monitor powers on, Input
terminal automatically switches.
If the monitor is already turned on when
the HDMI-CEC compatible device is
turned on, it only changes the Input
terminal.
Setup
Move Select
HDMI1
CEC
Auto Turn Off
Audio Receiver
Device list
Off
OK Return MENU EXIT EXIT
On
In the OSD menu, go to [Setup] -> [HDMI
Settings] -> and select [On] in [CEC].
Remote Control Pass
Through
The monitor’s remote control button
operation can function with HDMI-CEC
compatible devices connected with an
HDMI cable.
For example, part of the HDMI-CEC
compatible device menu can be operated
using the remote control.
Power Status The connected HDMI-CEC compatible
devices can obtain the monitor’s power
status, such as if the monitor is in standby
mode or on.
System Information This function obtains information from a
connected HDMI-CEC compatible device
(CEC version, physical address, etc.).
Auto Turn Off System Standby If the monitor is set to standby using the
remote control, the HDMI-CEC compatible
device connected with an HDMI cable
also goes into standby at the same time.
If the monitor goes into standby while
an HDMI-CEC compatible device is
recording, the device remains on.
Refer to the user’s manual supplied with
the HDMI-CEC compatible device for
further information.
In the OSD menu, go to [Setup] -> [HDMI
Settings] -> [CEC] and select [Enable] in
[Auto Turn Off].
Audio
Receiver
System Audio
Control
Connect audio equipment with the ARC
function to the HDMI1 (ARC) terminal
using the included ARC-supported HDMI
cable. The Volume buttons of the remote
control can control the volume of the
connected HDMI ARC audio equipment.
While this function is active, the monitor’s
internal speakers are automatically set to
MUTE.
In the OSD menu, go to [Setup] -> [HDMI
Settings] -> [CEC] and select [Enable] in
[Audio Receiver].
Search device Device OSD Name
Transfer
This function is used to obtain the name
of the connected devices.
In the OSD menu, go to [Setup] ->
[HDMI Settings] -> [CEC] -> [Device list]
and press the OK button of the remote
control.
Routing Control By selecting a device name, the HDMI-
CEC compatible device input switches to
the input you selected. After selecting the
device, the remote control operates for
the selected device.
NOTEN: Depending on the connected device, sometimes the device does not work properly.