Mounting (for trained installers) – NEC E558 55" Class 4K UHD Commercial LED TV User Manual

Page 18

English - 15

Mounting (for Trained Installers)

Carefully inspect the location where the unit is to be mounted. Not all walls or ceilings are capable of supporting the weight of

the monitor.

The weight of this monitor is provided in the specifications.
The product warranty does not cover damage caused by improper installation, re-modeling, or natural disasters.
Failure to comply with these recommendations could result in voiding the warranty.
Pay attention not to obstruct the air vents with the mounting brackets.

Mounting bracket

ARNINNN::

Please refer to the

"Important Information"

section.

• When using commercially-available mounting brackets, make sure that they

comply with the VESA Flat Display Mounting Interface Standard (FDMI).

• Check that the surface where the brackets will be attached is strong enough.
• Choose commercially-available mounting brackets strong enough to support the

weight of the monitor.

• Prior to mounting, inspect the installation location to ensure that it is strong

enough to guaranty safety.

• Pay attention not to obstruct part of the air vents of the monitor with the brackets.
• For detailed information, refer to the instructions included with the mounting

equipment.

• There are 4 installation holes on the back. Mount the monitor evenly at the four

locations.

(See “Mounting on Walls or Ceilings” for recommended installation examples.)

• Use screws of the sizes mentioned below to fix the brackets to the monitor. Tighten the screws securely.

Screw Size

Bracket Hole

No Thread

Recommended Fasten

Force

(A)

(B)

(C)

(D)

E328

13-15 mm

≤ Ø 8.5 mm

2.3 mm

390-520 N•cm

E438

4 mm

E498
E558
E658

4.5 mm

NOTEN:

When used in a video wall configuration for a long time, a slight expansion of the monitors may happen due to

temperature changes. It is recommended that a gap of over one millimeter is kept between adjacent monitor

edges.

> 1.0 mm

Screw (A)

Monitor

Diameter (C)

Gap

Washers

Mounting

bracket

No thread (D)

Thickness of

the bracket

and washers

(B)