Thor 4-Channel HDMI to QAM Modulator and IPTV Streaming Encoder with Low Latency - Manual (Page 8)

HDMI/SDI-QAM-IPLL
Thor Fiber Tel: (800) 521-84 Email: [email protected] https://thorbroadcast.com/ http://www.thormodulators.com/
Chapter 2 - Installation Guide
Please read the entire section in full before installing or operating your new Thor Broadcast
encoder to eliminate any chance of creating a faulty environment or recklessly damaging the
unit.
2.1 General Precautions

Must be operated and maintained in an area free of dust and debris.

The cover should be securely fastened, do not open the cover of the chassis when the power is on.
This will also void Thor’s manufacturer’s warranty.

After installation, securely stow away all loose cables, external antenna, and others.
2.2 Power precautions

Be careful when connecting a power source to the device.

Do not operate in wet or damp areas. Make sure the extension cable is in good condition

Make sure the power switch is off before you start to install the device
2.3 Device’s Installation Flow Chart Illustrate as following:
Connecting
Grouding
Wire and
Power
Cord
Acquisition
Check
Installing
Device
Setting
Parameter
Running
Device
Connecting
Signal
cable