Thor 4-Channel HDMI to QAM Modulator and IPTV Streaming Encoder with Low Latency - Manual (Page 13)

HDMI/SDI-QAM-IPLL
Thor Fiber Tel: (800) 521-84 Email: [email protected] https://thorbroadcast.com/ http://www.thormodulators.com/
3.1.2 Initial Status
After powering on the device
，
it will take a few seconds to initialize the system

DVB-C : indicates the modulation standard of this device.

A/B/C/D : indicates the 4 carrier outputs

XXX.XX MHz: Indicates the current output frequency (Range: 30~999MHz) of the 4 carriers
output.

X.XX Mbps : Indicates the encoding bitrate of each encoding output respectively.
3.2General setting for Main Menu
By pressing the “Lock” key on the front panel, enter the main menu. The LCD will display the
following pages:
Press UP/DOWN buttons to specify menu items, and then press ENTER to enter the submenus as
below:
1) Status
Press Enter to enter “Status” and it displays the working time duration of the device
2) Input Sets
Under this submenu, the LCD will show “2.1 Input 1”, “2.2 Input 2” and “2.3 Input 3”.
Start up…
Start OK…
DVB-C A XXX.00MHz
P1 X.XXMbps P2 X.XXMbps
1 Status
2 Input Sets
1 Status
2 Modulator
3 Modulator
4 TS Config
5 Network
6 System
1.1 Uptime Uptime
2 Days-10:30:20
2 Days-10:30:20
2.1 Input 1
2.2 Input 2 2.3 Input 3