HP OMEN 27s 27" HDR 240 Hz Gaming Monitor - Manual (Page 29)

To use PiP or PbP:
1. Connect a secondary input source to the monitor.
2. Press the center of the OSD controller on the rear of the monitor to open the OSD.
3. In the OSD, select Split Screen and then select PiP (Picture-in-Picture) or PbP (Picture-by-Picture).
The monitor scans the secondary inputs for a valid signal input and uses that input for the PiP or
PbP picture.
4. If you want to change the PiP or PbP input, select PiP Control in the OSD, and then select Assign
Inputs.
5. If you want to change the size of the PiP, select PiP Size in the OSD, and then select the size that you
want.
6. If you want to adjust the position of the PiP, select PiP Position in the OSD, and then select the
position that you want.
Using external lighting (select products only)
Some monitors feature an external light to illuminate a desktop or wall and enhance the gaming
experience. You can adjust the color and brightness of the external light or turn it off in the OSD menu or
OMEN Gaming Hub.
To adjust the ambient lighting:
1. Press the center of the OSD controller on the rear of the monitor to open the OSD menu.
2. In the OSD, select External Lighting.
3. Select a setting:
● Off: Turns off the ambient lighting.
● Color Cycle: Slowly fades in and out from one color to another.
● Breathing: Slowly fades in and out on one single color with adjustable speeds - Slow, Medium,
and Fast.
● Static Color: Sets ambient light colors to red, green, blue, yellow, purple, cyan, orange, or
custom.
● Random Color: Randomly cycles ambient light color through the static colors.
● LED Brightness: Adjusts the ambient lighting brightness.
NOTE: External lighting is set to On (OMEN White) by default.
24 Chapter 2 Using the monitor