HP OMEN 27s 27" HDR 240 Hz Gaming Monitor - Manual (Page 16)

IMPORTANT: To position and stabilize the monitor, HP recommends that two people perform these
procedures.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor facedown on a flat surface covered by protective sheet made of foam or a
clean, dry cloth.
CAUTION: If you are removing the stand from a curved monitor, position the monitor facedown in
the original packing box. Then remove the stand. Positioning a curved monitor facedown on a flat
surface might damage the monitor.
3. Push up the latch near the bottom center of the stand’s mounting plate (1).
4. Lift the stand up and off the monitor head (2).
Attaching the monitor head to a mounting device
You might need additional tools such as a screwdriver (purchased separately) when you attach a
mounting device. To avoid damage to your monitor, follow these instructions.
1. Remove the four screws from the VESA holes located on the rear of the monitor head.
Attaching the monitor head to a mounting device 11