Sony HVL-F20M External Flash - Manual (Page 21)

21
[Referer] tab
Use the [Referer] tab to configure the Referer
check function. “Referer Check” is a function that
checks whether the web page which requested
the access is legitimate when the unit is
accessed from an external source. If the web
page cannot be confirmed as legitimate, access
is denied.
If you want to access the unit from a web page
other than one that the unit provides, register
the host name and port number that hosts the
web page on this tab.
To enable Referer check
Select [Enable] in [Referer Check]. The following
[Exception List] items can be configured when
Referer check is enabled.
[No. 1] to [No. 10]: Register hosts that are not
subjected to the Referer check as an
exception list.
[Host Name]: Enter the host name or IP address
of the computer that hosts the web page you
want to register in the exception list.
[Port No.]: Enter the port number of the
computer that hosts the web page you want
to register in the exception list.
[Reset]: Reset the exceptions settings.
[External System] Page
You can set whether to allow or disable control
of this unit by other models on the same network
as the unit.
Only enable this function if the unit is connected
to a secure network.
[On]: Allow control of this unit by other models.
[Off]: Disable control of this unit by other
models.
Note