Sony HVL-F20M External Flash - Manual (Page 18)

18
[Security] Page
Use to configure settings relating to security on
the unit.
The screen consists of [User], [Access], [SSL], and
[Referer] tabs.
[User] tab
Use to configure users.
You can configure the user name, password, and
user access permissions of one administrator
and nine general users.
Administrator and general users
Users on the unit are categorized into
administrator and general users.
An administrator can access all settings and
operate the unit. A general can access some
settings and operate the unit.
[Administrator], [User 1] to [User 9]
Set the following items for the administrator and
each general user.
[User Name]: Enter a user name comprising 5 to
16 characters.
[Current Password]: Enter the currently
configured password comprising 8 to 64
characters.
[New Password]: Enter the new password you
want to set comprising 8 to 64 characters.
[Re-type Password]: Re-enter the new
password you want to set to verify the
password.
Administrator permission selection: To grant
administrator access to a user, select
[Administrator]. To set a general user without
administrator access, select [User].
• The following characters are valid in user
names and passwords. Include at least one
upper-case letter, one lower-case letter, and
one number in passwords.
– Alphanumeric characters
– Symbols (!$%'()=-~^|@`[{}]_/?<>+*.)
• A user name and new password must be
configured when adding a user.
• To change the user information, all items must
be specified again.
• When deleting a user, leave all fields other
than [Current Password] blank.
[Access] tab
Use to configure the security function to restrict
the computers that can access the unit.
Similarly, you can also configure security for each
network when using IPv6.
To enable IP address restrictions
Select [Enable] for [Access restricted by IP
address], and configure the following items.
[Default Policy]
Select [Allow] or [Deny] to allow or deny access
from computers whose network address is
outside the ranges configured in [Network
Address/Subnet 1] to [Network Address/Subnet
10].
[Network Address/Subnet 1] to [Network
Address/Subnet 10]
Enter the network address/subnet mask value
that you want to allow or deny access.
You can specify up to ten network addresses and
subnet mask values.
Enter a subnet mask value of 8 to 32 (8 to 128 for
IPv6).
Set access to [Allow] or [Deny] individually for
each network address/subnet mask.
Notes