Troubleshooting – Roland TD-02K V-Drums Electronic Drum Kit User Manual
Page 22
22
22
Troubleshooting
Problem
Items to Check
Action
Page
Troubles with sound
No sound/
insufficient volume
Is this unit correctly connected to the
amplified speaker or headphones?
Connect amplified speakers or headphones to
this unit’s OUTPUT/PHONES jack.
If you’re connecting an amplified speaker, connect
to the amplified speaker’s input jack.
–
Is the dedicated connection cable correctly
connected to the TRIGGER INPUT connector
located on the back of this unit?
Check the connections.
“Setup
Guide”
Could an audio cable of headphones or
amplified speaker be broken?
Replace the cable.
–
If sound is not output from the amplified
speaker that’s connected, is sound
outputted when you connect headphones?
If sound is being output, either the connection
cable of the amplified speaker is broken, or there
is a malfunction in the amplified speaker that’s
connected. Check the connected device and
cable.
–
Could the instrument’s volume be lowered?
Adjust the level appropriately.
–
Could the volume of the connected
amplified speaker be lowered?
Could the volume be lowered on the
mobile device that’s connected to the MIX
IN jack or via Bluetooth?
A specific pad does
not sound
Are the cables correctly connected to each
pad and pedal?
Connect the appropriately labeled cable to each
pad.
“Setup
Guide”
Could the pad sensitivity be lowered?
Adjust the pad sensitivity (Sens).
If you expanded the pads or replaced a pad
with a different type of pad, is the pad type
specified correctly?
Adjust the pad type.
No sound when you
press the kick pedal
Is the cable labeled KIK connected to the
kick pad?
Check the connections.
“Setup
Guide”
No sound when
you press the hi-hat
pedal
Is the cable labeled HHC connected to the
hi-hat pedal?
The sound of
another pad is also
heard when you
strike the pad.
If multiple pads are attached to the same
stand, the vibrations when you strike one
pad can be transmitted to another pad,
causing it to sound inadvertently.
Note the following points, and make changes to
the attached positions.
¹
Separate the pads so that they do not touch
each other.
¹
Firmly tighten the knobs that fasten the pad
to ensure that the pad is securely attached to
the stand.
In some cases, sound from a monitor speaker
might cause unintended triggering.
¹
Set up the pads at a distance from the speakers
¹
Angle the pads, placing them where they are
less likely to be affected by the sound
¹
Increase the pad’s minimum sensitivity value
(Threshold) (p. 14)
–
Two or more notes
are sounded when
you strike once
Is the pad fastened to the stand?
Fasten the pad firmly to the stand.
Also set the RetrigCancel parameter.
Sounds do not play
reliably
Are the snare and tom pad mesh heads (the
snare of the TD-02KV) tensioned evenly?
Adjust the mesh head tension (the snare of the
TD-02KV). Use a drum key to adjust the pad’s
tuning bolts. Slightly higher tension is good for
proper triggering.
“Setup
Guide”