beautypg.com

Adjusting the head tension, Replacing the head or hoop rubber, Replacing the head – Roland PD-140DS V-Pad Digital Snare User Manual

Page 3

background image

3

Adjusting the Head Tension

Before playing, you must adjust the head tension first.
You can tune/adjust the head tension as you would with an

acoustic drum, to get the same dynamic “feel.”

The pad will function at it’s best if you are sure to:

5

Adjust the head evenly so that it does not sag.

5

Adjust the tuning bolts so that they are not loose.

1

2

3

4

5

7

8

6

1.

Adjust each tuning bolt little by little, across the head as

indicated in the illustration.

* Fully tightening a tuning bolt at only a single location produces

uneven tensioning, and correct playing dynamics may not

be achieved or may even cause malfunctions. Even tuning/

tensioning is very important.

2.

Adjust the tightness of each tuning bolt so that the head

is tensioned evenly.

MEMO

5

Head tension will not affect the actual tuning of the sound you

are playing. For that you need to adjust sound parameters in

the sound module you are using. For details, refer to the owner’s

manual of your drum sound module.

5

Also, head tension may change depending on usage. Adjust as

needed.

Replacing the Head or Hoop Rubber

The performance of the head and/or hoop rubber will diminish

with use over time. If the head is torn or becomes too fatigued, or

impossible to tension correctly, then it should be replaced. If the

hoop rubber is worn out, it too can be replaced.
For replacement heads or to have the hoop rubber replaced, please

contact your dealer or a Roland service center.

Replacing the Head

NOTE

Applying excessive force to the sensors located under the head

can damage them and/or interfere with accurate triggering.

1.

Remove all tuning bolts.

Go around and loosen each bolt a little at a time by turning it

counter-clockwise.

2.

Remove the hoop and old head.

Hoop

Head

Do not touch the sensors located at

the top of the frame.
Otherwise, you risk causing damage

or malfunction.

3.

Place the new head and hoop on the shell.

4.

Install all eight tuning bolts.

5.

Adjust the tension of the head.

Refer to “Adjusting The Head Tension” above.