Roland VC-100UHD 4K Video Scaler/Converter/Streamer - Manual (Page 3)

3
Panel Descriptions
Name Explanation
5 AUDIO IN/OUT connector
This connector provides analog audio signal input/output (two balanced
inputs and two balanced outputs).
The output signal is the same as the output signal of the LINE OUT jacks.
G
C
H
G
C
H
G
C
H
G
C
H
CH 3 (L)
ANALOG IN ANALOG OUT
CH 4 (R) CH 1 (L) CH 2 (R)
6 LINE IN jacks (L, R)
These jacks input audio. Connect them to an audio mixer, CD player, or other audio or video device.
CH 1 is L and CH 2 is R.
7 LINE OUT jacks (L, R)
These jacks output audio. Connect them to an audio recorder, amp, or speaker.
CH 1 is L and CH 2 is R.
8 REMOTE connector This allows you to remotely control this unit from a computer using terminal software.
9 USB HOST port
A USB flash drive can be connected to this port. This is used when saving/loading settings for the unit or when
updating the system program.
* While the screen indicates “Processing,” never turn off the power or disconnect the USB flash drive.
10 STREAMING port
This is a USB 3.0 B-type port for video/audio output.
When you connect it to a USB port of your computer, this device is recognized as a web camera.
11 HDMI 4K IN connector
This connector can input video up to 4K. Connect a video device or computer here.
HDMI 2.0b 18 Gbps HDCP 2.2 is supported.
12 HDMI 4K OUT connector
This connector can output video up to 4K. Connect a video recording device or display here. Depending on the
setup settings, the signal of the HDMI 4K IN connector can be “thru-output” from here.
HDMI 2.0b 18 Gbps HDCP 2.2 is supported.
13 12G-SDI THRU connector
The video that is input from the 12G-SDI IN connector is output without change from this connector.
A re-clocker is built in.
14 12G-SDI IN connector
This connector can input video up to 4K. Connect a video camera or similar device here.
Input up to 12G-SDI is supported.
15 12G-SDI OUT connector
This connector can output video up to 4K. Connect a video recording device or display here.
Output up to 12G-SDI is supported.
16 REFERENCE IN connector
This connector inputs an analog external synchronization signal.
Black burst/2-value/3-value synchronization signals are supported.
17
REFERENCE THRU/OUT
connector
When this unit is operating with internal synchronization, the internal synchronization signal of the unit is output as
black burst.
When this unit is operating with external synchronization, the external synchronization input is “thru-output.”
18 DC IN jack
Connect the included AC adaptor to this jack.
You can secure the plug of the AC adaptor by attaching the included DC plug stopper.
* The DC plug stopper can also be attached to the left side of the unit and used as a cable holder.
DC plug stopper
Attaching screw
DC plug stopper
Attaching screw
19 Ground terminal Connect this to an external earth or ground. Connect this if necessary.
7
15 17
19
8 5 6
9 11 12 13 14 16 10 18
Screw for
attaching DC plug stopper
Rear Panel