Samsung 49" Odyssey G9 32:9 240 Hz Curved HDR G-SYNC VA Gaming Monitor - Manual (Page 35)

35
DisplayPort Ver.
Select your Displayport.
―
Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
―
If the product (when set to DisplayPort ) is displaying the message Check the cable connection and the
settings of the source device. press the JOG button to display the Function Key Guide screen and then select
→ System → DisplayPort Ver. → 1.1 , 1.2 or 1.4 .
―
If setting the DisplayPort Ver. to 1.1 , for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual
maximum output refreshing rate of the graphics cards cannot achieve the level of 120 Hz/144 Hz (C27G7*T* /
C32G7*T*), 120 Hz (C49G9*T*).
―
If the PC has entered BIOS mode and the BIOS screen does not appear, go to the following path and then
select the mode.
→ System → DisplayPort Ver. → 1.1 or 1.2 .
―
The DisplayPort Ver. option is disabled if Adaptive-Sync is set to On and there is a signal input.
―
C49G9*T* model only.
Input Port Ver.
Select an HDMI version.
―
The supportable device and resolution may differ depending on its version.
―
When the version is changed, the screen may blink.
―
If you set the HDMI Mode to 1.4 , some high resolutions may not be supported because of bandwidth
limitation of the HDMI 1.4 protocol.
―
When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
device.
―
Set HDMI Mode to 1.4 if the monitor is connected to an HDMI device and the monitor does not display the
screen properly, displays a blank screen, or does not play sound at all.
Auto Source Switch
By activating, a new connected source is displayed automatically.
―
This function may not be supported depending on the model or geographical area.
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration , 1 sec , or 2 sec can be selected. If No Repeat is selected, a command responds only once
when a button is pressed.
Power LED On
Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working : The power LED is on when the product is turned on.
• Stand-by : The power LED is on when the product is turned off.