Instructions for use, Selective room cleaning, Pin n go – Roborock S6 MaxV FCC User Manual

Page 25: Cleaning mode, Dnd mode, Scheduled cleaning, Zone cleaning

Instructions for use

Selective Room Cleaning

Select one or multiple rooms for cleaning in the app.

Pin n Go

Place a target on the map in the app and the robot will navigate to the
desired spot.

Cleaning Mode

Select Quiet, Balanced, Turbo, or MAX mode in the app. Balanced mode is
selected by default.

DND Mode

During the DND period, the robot stops cleaning and playing voice
prompts, and the power indicator dims. DND mode is enabled in factory
settings. The default DND period is from 22:00 to 08:00. You can use the
app to disable the DND mode or modify the DND period.

Scheduled Cleaning

Use the app to set start times for scheduled cleanings. The robot will
return to the Charging Dock after each cleaning cycle.

Zone Cleaning

Note:

The robot may enter unselected areas during cleaning. Clear obstacles from the ground around the

selected zones as the robot may enter unselected areas.

Note:

A full map must have been created, and Map Saving mode switched on before this function can be used.

The robot may enter unselected areas during cleaning. Clear obstacles from the ground around the

selected rooms as the robot may enter unselected areas.