Roborock S6 MaxV FCC - Manual (Page 18)

16
Using the Robot
> 0.5m
> 0.5m
> 1.5m
Place the charging dock
Secure the charging dock with the adhesive tape.
1.
2.
the power cable to the Charging Dock and place any exposed cable
into the cable slot. To ensure a better user experience of the mobile
app, place the Charging Dock in an area with good WiFi coverage.
the dock onto the double-sided tape to secure it in place.
Double-sided tape
Note:
Note:
Allow at least 0.5m (1.6ft) of clearance on each side, and more than 1.5m (4.9ft) in front of the
Charging Dock.
If the power cable hangs vertical to the ground, it may be caught by the robot, causing the Charging
Dock to be disconnected.
charging.
Do not place the Charging Dock in places that are directly exposed to sunlight, and do not block the
Location Beacon. Otherwise the robot may not be able to automatically return to the Charging Dock.
Use double-sided tape to stick the Charging Dock down.
Use of the double-sided tape to secure the charging dock is optional.
When necessary, remove the double-sided adhesive tape slowly to reduce residue glue.
Installation