Roborock S6 MaxV FCC - Manual (Page 23)

21
Instructions for use
Start Cleaning
Press and hold the button to power on the robot. The power indicator
will turn on and the robot will enter standby mode. When the robot is
cleaning cycle.
Press the button to start cleaning. The robot will plan its cleaning
Note:
Zone 1 has
been cleaned.
Zone 4 is
pending.
Zone 2 has
been cleaned.
Zone 3 is
being cleaned.
Note:
Cleaning cannot start if the battery level is too low. Allow the robot to charge before restarting cleanup.
may be dragged by the robot, resulting in the disconnection of electrical appliances or damage of cables
and property.
If cleaning is completed in less than 10 minutes, the area will be cleaned twice.
If the battery runs low during the cleaning cycle, the robot automatically returns to the Charging Dock.
Sleep
If the robot is paused for over 10 minutes, it will go to sleep, and the
robot up.
Note:
The robot will not go to sleep when it is on the Charging Dock.
The robot will automatically shut down if left in sleep mode for more than 12 hours.
Pause
When the robot is running, press any button to pause it.
Then press the button to continue cleaning or the button to
return it to the Charging Dock and stop the cleaning cycle.
Note:
Placing a paused robot on the Charging Dock manually will end the current cleanup.