Epson Stylus CX7800 - Manual (Page 6)

Epson Stylus CX7800
6 - Epson Stylus CX7800 8/05
As with traditional photos, Epson recommends proper care
that will minimize color changes and lengthen display life:
❏ Frame prints under glass or a protective plastic sleeve to
protect them from atmospheric contaminants like
humidity, smoke, and high levels of ozone.
❏ As with all photographs, keep your prints away from direct
sunlight.
❏ For proper storage, keep your prints in a photo album or
plastic photo storage box in acid-free, archival sleeves
commonly available from most camera stores.
❏ Always keep unused paper in the original package.
Placing Originals for Copying or
Scanning
1. Open the document cover and place your original face-
down on the glass, in the upper left corner. Move your
original about 0.2 inch (5 mm) away from the top and left
edges so all of it will be copied.
2. Close the document cover gently so that your original does
not move.
Caution:
Never open the document cover beyond where it stops and do
not place heavy objects on top of the Epson Stylus CX7800.
If you need to copy or scan a thick or large document, you can
leave the document cover open.
If you need to press the document flat while you copy or scan
it, do not press too hard and be careful not to move it.
Caution:
Do not use excessive force on the document cover, and do not twist
it. You may damage the document cover.
When you are done, close the document cover.
Copying
You can make copies using either letter-size (8.5 × 11-inch)
plain paper, or letter-size, 4 × 6-inch, or 5 × 7-inch photo
paper.
Copying a Document
1. Make sure the Epson Stylus
CX7800 is turned on.
2. Place the document on the
glass as described on page 6.
Be sure to close the document
cover.
3. Load up to 100 sheets of letter-size plain paper, as described
on page 4.
4. Press the Copy mode button. The 100% light turns on.
5. If you want your copies automatically reduced or enlarged
to fit the loaded paper size, press the Copy mode button to
select Fit to Page .
6. Press the u or d Copies button to set the number of
copies.
7. Press the l or r Photo/Options button to select Color or
B&W copy.
8. Press the paper type button to select Plain Paper . The light
indicates which type is selected.
9. Press the paper size button to select Letter .
10. Press the x Start button.
The P On light flashes and the Epson Stylus CX7800 starts
printing.
To cancel copying, press the y Stop/Clear Settings button.
Do not pull out paper that is being printed; it will be ejected
automatically to the output tray.
Note:
The copies may not be exactly the same size as the original.
Move the original about 0.2 inch (5 mm) away
from the top and left edges to avoid cropping