Yamaha CVP-705B User Manual
Page 84
Song Settings Related to Playback/Recording
CVP-709/CVP-705 Reference Manual
84
3
Select a MIDI Song to be re-recorded.
4
Press the [ ](REC) button to call up the Song Recording display, and then confirm that
[Overwrite MIDI] is selected.
If the Channel area is not shown, touch [
] at the left of “Channel.”
5
From the display, set the part or parts you intended to re-record to [Rec], and set all other
parts to [Off].
NOTE
For details about the recording channels, refer to the Owner’s Manual.
Mode
Rec Start
Determines the recording start behavior.
• Normal: Overwrite recording starts when Song playback is started via the
SONG [
/
] (PLAY/PAUSE) button or when you play the keyboard in the
Synchro Standby mode.
• First Key On: The Song plays back normally, then starts overwrite recording
as soon as you play the keyboard.
• Punch In At: The Song plays back normally up to the beginning of the
“Punch In At” measure specified in the Punch In/Out parameter below, then
starts overwrite recording at that point.
Mode
Rec Stop
Determines the recording stop behavior, or how data is handled after
recording is stopped.
• Replace All: This deletes all data after the point at which recording is
stopped.
• Punch Out: The Song position at which recording is stopped is regarded as
the Punch Out point. This setting maintains all data after the point at which
recording is stopped.
• Punch Out At: Actual overwrite recording continues until the beginning of
the “Punch Out” measure specified in the Punch In/Out parameter below, at
which point recording stops and normal playback continues. This setting
maintains all data after the point at which recording is stopped.
Punch In/
Out
Punch In At
Specifies the Punch In measure.
Punch Out At
Specifies the Punch Out measure.
Pedal Control
When this is set to “On,” you can use the center pedal to control the Punch
In and Punch Out points. While a Song is playing back, pressing (and
holding) the center pedal instantly enables Punch In recording, while
releasing the pedal stops recording (Punch Out). You can press and release
the center pedal as often as you want during playback. Note that the current
function assignment of the center pedal is cancelled when the Pedal Punch
In/Out function is set to “On.”
NOTE
Pedal Punch In/Out operation may be reversed depending on the particular
pedal you’ve connected to the instrument. If necessary, change the pedal
polarity to reverse the control (