ProSoft Technology AN-X-AMX - Manual (Page 34)

Page 30 AN-X-AMXCAPT January 2008
Selecting an AN-X
Before you can perform an operation on an AN-X, you must select it. Choose
Utilities/Select An AN-X to select a specific AN-X.
From the Adapter list, select the network adapter that connects to the Ethernet network
that contains the AN-X.
In the Ethernet MAC Address field, enter the MAC Address of the AN-X you wish to
select. It can be found on the AN-X label or using the Locate All AN-X Modules
command. The format is as shown above, six pairs of hexadecimal digits separated by
hyphens.
In the IP Address field, enter the Ethernet IP address of the AN-X you wish to select. It
can be found using the Locate All AN-X Modules command. The format is as shown
above, four decimal numbers each in the range 0 to 255.
Both MAC address and IP address must match the settings on the AN-X in order for
communication to occur.
Click OK to select the AN-X.