ProSoft Technology ILX34-MBS485 - Manual (Page 27)

Configuration
ProSoft Technology, Inc. Page 27 of 34
February 18, 2015
3.5 Downloading the Sample Program to the Processor
Note: The key switch on the front of the ControlLogix processor must be in the
REM or Prog position.
1. If you are not already online with the processor, open the
Communications menu, and then choose Download. You do not have to
download through the processor’s serial port. You may download through
any network connection.
2. When communication is established, Studio 5000 (or RSLogix 5000)
opens a configuration dialog box. Click the Download button to transfer
the sample program to the processor.
3. Studio 5000 (or RSLogix 5000) compiles the program and transfers it to
the processor. This process may take a few minutes.
4. When the download completes, the configuration program opens another
Confirmation dialog box. If the key switch is in the REM position, click OK
to switch the processor from PROGRAM mode to RUN mode.
Note: If you receive an error message during these steps, refer to the Rockwell
Automation documentation to interpret and correct the error.