ProSoft Technology ILX34-MBS485 - Manual (Page 15)

Configuration
ProSoft Technology, Inc. Page 15 of 34
February 18, 2015
3 Configuration
The ILX34-MBS module supports several Point I/O Controllers and Adapters.
This includes:

1734-AENT and AENTR

1734-ACNR

1769-L16ER-BB1B

1769-L18ER-BB1B

1769-L18ERM-BB1B
3.1 1734-AENT and 1734-AENTR
To configure the ILX34-MBS module with a 1734-AENT adapter:
1. Refer to the 1734-AENT documentation for information on configuring the
adapter.
2. Refer to Create Module I/O Configuration on page 18 to configure the
ILX34-MBS module for this adapter.
3. Set the chassis size as described in the 1734-AENT/AENTR
documentation.
3.2 1734-ACNR
To configure the ILX34-MBS module with a 1734-ACNR adapter:
1. Refer to the 1734-AENT documentation for information on configuring the
adapter.
2. Refer to Create Module I/O Configuration on page 18 to configure the
ILX34-MBS module for this adapter.
3. Schedule the ControlNet as described in the 1734-ACNR documentation.
3.3 1769-L16ER-BB1B, L18ER-BB1B, and L18ERM-BB1B
Follow the instructions is the Sample Configuration procedure in this section.
3.4 Sample Configuration Procedure
Note: The following example procedures are accomplished using Rockwell
Automation's Studio 5000 Designer, but apply to RSLogix as well. If you are
installing this module into a 1734-AENT or ACNR, use RSLogix 5000 v16 or
greater and skip to the section entitled Create Module I/O Configuration.
1. Open Studio 5000 and click Create New Project.
2. Expand CompactLogix 5370 Controller. Select the appropriate
processor from the list: