PLANET NAS-7200 - Manual (Page 7)

Ready/Status
Ready (Green)
ON – Normal operation.
OFF – No power.
Blinking – This LED blinking during startup and shutdown.
Status (Amber)
ON – This LED will be On during the Startup self-test; it will
turn Off once the self-test is completed. If it stays ON, there is
a hardware error.
OFF – Normal operation.
Blinking – During a software upgrade, both the Status and
Ready LEDs will blink.
LAN
ON – Link established.
OFF – No LAN connection.
Blinking – Data is transmitted or received via the LAN.
HDD
OFF – Idle.
Blinking – Hard disk is being accessed.
HDD Full
ON - Disk is completely full. No more data can be stored on
this disk
OFF -Normal operation, disk is not full.
Blinking - Disk is 98% full (The Buzzer will also beep 3 times.)
HDD 1
ON – Disk 1 installed
OFF – Disk 1 not installed
Blinking – Raid 1 Rebuilding
HDD 2
ON – Disk 2 installed
OFF – Disk 2 not installed
Blinking – Raid 1 Rebuilding
USB 1
ON - USB device connected to the USB port
OFF - No USB device installed
Fast Blinking - Data being transferred to or from the USB device
USB 2
ON - USB device connected to the USB port
OFF - No USB device installed
Fast Blinking - Data being transferred to or from the USB device