PLANET NAS-7200 - Manual (Page 12)

12
Chapter 4. System Installation
Boot up
1. Connect the network cable to LAN port on the rear of SATA NAS Server. Connect
the others end to your hub or switch.
2. Connect the supplied power adapter to a power outlet and plug the power cord
into SATA NAS Server’s power input on the rear panel.
3. Power on.
Locate the SATA NAS Server’s power switch on the NAS-7100 real panel. Press it
once to power on the NAS
4. The SATA NAS Server self-test.
The SATA NAS Server will run a brief self-test. During the self-test, all of SATA
NAS Server’s LED will be illuminated or flashing.
5. Booting up.
When the self-test is complete, boot up will start. The Ready LED will blink
continuously, and the LAN LED will blink occasionally. Boot up should take
approximately 1-3 minutes.
6. Boot up completed.
When the Ready LED stops blinking, and remains on, boot up is complete. If
the Status (Orange) LED stays on, or if the SATA NAS Server repeatedly beeps,
there is a hardware problem. Consult the Troubleshooting section of the User
Guide for possible solutions.
Shutdown
To shutdown the SATA NAS Server, press the power switch to start the shutdown
sequence. Wait for all LEDs to turn off.
Removing a USB device
1. Press the USB eject button (for USB 1 or 2) on the rear panel.
2. Wait for the “USB" LED turn off.
3. Remove the USB device.
You can also use the Windows utility installed from the CD-ROM:
1. Select “Safely Remove USB Device"
2. Select the desired NAS and USB device, and click the "Eject" button.
3. Wait for the message telling you it is safe to remove the USB device.