PLANET NAS-7200 User Manual

Page 10

3.2 NAS-7200 - 2-Bay SATA NAS RAID Server

The NAS-7200 supports two 3.5-inch Serial-ATA (SATA) hard drives. NAS-7200
does not support low profile or half high hard drive.

HDD Install

1. Make sure the NAS-7200 is powered off

2. Open rear cover of NAS-7200

3. Make sure your hard drive is SATA interface and make sure you back up all pre-

existing data before use it on NAS-7200

4. To install Disk 1 that located on left side (rear view), make sure HDD top face to

left and connector side in front then slide the HDD into slot