PLANET WSG-500 - Manual (Page 18)

18
Appendix B. Firmware Upgrade
Software tools tftpd32 is required in the upgrade procedure, please download and
install tftpd32 before you proceed further.
Note
Tftpd32 can be downloaded from the following link: http://tftpd32.
jounin.net/tftpd32.html
Step1: Place the new firmware of WSG-ACG5 on a local location (for example
desktop) in the PC that is accessing WSG-ACG5’s web interface and
performing the upgrade.
Step2: Configure the TCP/IP settings of your PC with an IP address under the
same subnet mask as WSG-ACG5. For example 192.168.1.20
Step3: Launch tftpd32 and click the DHCP tab.
1. In “Current Directory” field, browse for the location path where the
firmware is stored.
2. Enter the IP address of your PC in “Server interfaces” field.
3. In “IP pool starting address” field, enter the start IP address of an IP
segment that is available for allocation.
4. Set the size of the IP pool.
5. Enter the firmware filename in “Boot file field”.
6. Enter 255.255.0.0 in the “Mask” field.
7. Click Save button.
Note
Please make sure that the location path and the firmware for
upgrade is correct.