PLANET ICA-H612 - Manual (Page 46)

If Motion Detection function is activated, the pop-off window (Motion) with indication of motion will be
shown.
When motion is detected, the signals will be displayed on the Motion window as shown below.
Detailed settings of Motion Detection are described as follows:
Motion Detection
You will be able to turn on/off Motion Detection in System section. Default setting is Off.
Motion Detection Setting
Users could adjust various parameters of Motion Detection in this section.
• Sampling pixel interval [1-100]:
The default value is 10, which means system will take one sampling pixel for every 10 pixel.
• Detection level [1-100]:
The default level is 10. The item is to set detection level for each sampling pixel; the smaller the value,
the more sensitive it is.
• Sensitivity level [1-100]:
The default level is 80, which means if 20% or more sampling pixels are detected differently, system will
detect motion. The bigger the value, the more sensitive it is. Meanwhile, when the value is bigger, the
red horizontal line in the motion indication window will be lower accordingly.
- 46 -