PLANET WNRT-627 User Manual
Page 77
User’s Manual of WNRT-627
-70-
Incoming Protocol
The protocol used for Incoming Ports Range, either
TCP or UDP, or ALL
(all protocols supported by the Router).
Status
The status of this entry either
Enabled or Disabled.
Table 5-25
To add a new rule, follow the steps below.
Step 1. Click the
Add New… button, the next screen will pop up as shown in
Step 2. Select a common application from the
Common Applications drop-down list, then the
Trigger Port field and the Incoming Ports field will be automatically filled. If the Common
Applications do not have the application you need, enter the Trigger Port and the
Incoming Ports manually.
Step 3.
Select the protocol used for Trigger Port from the
Trigger Protocol drop-down list, either
TCP, UDP, or All.
Step 4.
Select the protocol used for Incoming Ports from the
Incoming Protocol drop-down list,
either
TCP or UDP, or All.
Step 5. Select
Enable in Status field.
Step 6. Click the
Save button to save the new rule.
Figure 5-27 Add or Modify a Triggering Entry