PLANET WNRT-300 - Manual (Page 37)

User’s Manual of WNRT-300
-31-
4.4.5. WDS Settings
Wireless Distribution System (WDS) uses wireless media to communicate with other APs, like the
Ethernet does. To do this, you must set these APs in the same channel and set MAC address of
other APs which you want to communicate with in the table and then enable the WDS.
Choose menu “Wireless  WDS Settings”, and you can configure WDS to connect the WNRT-300
with another AP in this page. After the configuration, please click the “Apply Changes” button to save
the settings.
Figure 4-16 WDS Settings
Object Description
Enable WDS Check the box to enable the WDS function. Please select WDS or
AP+WDS in the Mode of Wireless Basic Settings before you enable
WDS in this page.
MAC Address You can enter the MAC address of the AP you want to connect with.
Data Rate Default is “Auto”.
Comment You can make some comment for each MAC address on the list.
Set Security Click the “Set Security” button, then configure the wireless security
parameters of the AP you want to connect via WDS.
Show Statics Click the “Show Statics” button to show the WDS AP.