PLANET WNAP-6300 - Manual (Page 48)

Chapter 5 Management Page 39
Chapter 5 Management
5.1 SNMP Management
The WNAP-6300 supports SNMP for convenient remote management. Open “SNMP Configuration”
in “Management” shown below. Set the SNMP parameters and obtain MIB file before remote
management.
Figure 31 SNMP Configuration
Enable SNMP
Check this box to enable SNMP settings.
Protocol Version
Select the SNMP version, and keep it identical on the WNAP-6300 and the SNMP manager.
Server Port
Change the server port for a service if needed; however you have to use the same port to use that
service for remote management.
Get Community
Specify the password for the incoming Get and GetNext requests from the management station.