Chapter 3. connecting to the router, 1 system requirements, 2 installing the router – PLANET WDRT-750AC User Manual
Page 16: Chapter 3, Connecting to the router, System requirements, Installing the router
User Manual of WDRT-750AC
-10-
Chapter 3. Connecting to the Router
3.1 System Requirements
Broadband Internet Access Service (Cable/xDSL/Ethernet connection)
One Cable/xDSL Modem that has an RJ-45 connector (not necessary if the Router is connected
directly to the Ethernet.)
PCs with a working Ethernet Adapter and an Ethernet cable with RJ-45 connectors
PC subscribers use Windows 98/ME, NT4.0, 2000/XP, Windows Vista / Win 7, MAC OS 9 or later, or
Linux, UNIX or other platforms compatible with TCP/IP protocols
The above PC is installed with a Web browser
1. The Router in the following instructions means PLANET WDRT-750AC.
2. It is recommended to use Internet Explore 7.0 or above to access the Router.
3.2 Installing the Router
Before installing the Router, make sure your PC is connected to the Internet through the broadband service
successfully at this moment. If there is any problem, please contact your local ISP. After that, please install the
Router according to the following steps. Don't forget to pull out the power plug and keep your hands dry.
Step 1. Power off your PC, Cable/xDSL Modem, and the Router.
Step 2. Locate an optimum location for the Router. The best place is usually at the center of your wireless
network.
Step 3. Adjust the direction of the antenna. Normally, upright is a good direction.
Step 4. Connect the PC or Switch/Hub in your LAN to the LAN Ports (Yellow ports) of the Router with Ethernet
cable, shown in