Appendix a. networking connection, A.2. 10/100mbps, 10/100base-tx – PLANET IAP-2000PE User Manual
Page 80
User’s Manual of IAP-200x Series
-79-
Appendix A. Networking Connection
A.1. DATA OUT PoE Switch RJ-45 Port Pin Assignments (Port-1 to
Port-4)
PIN NO
RJ-45 SIGNAL ASSIGNMENT
1
Output Transmit Data +
Power +
2
Output Transmit Data –
Power +
3
Receive Data +
Power -
4 -
5 -
6
Receive Data –
Power -
7 -
8 -
Figure A-1
A.2. 10/100Mbps, 10/100Base-TX
When connecting your 10/100Mbps Ethernet Switch to another switch, a bridge or a hub, a straight or crossover
cable is necessary. Each port of the Switch supports auto-MDI/MDI-X detection. That means you can directly
connect the Switch to any Ethernet devices without making a crossover cable. The following table and diagram
show the standard RJ-45 receptacle/ connector and their pin assignments:
RJ-45 Connector pin assignment
Contact
MDI
Media Dependant Interface
MDI-X
Media Dependant Interface-Cross
1
Tx + (transmit)
Rx + (receive)
2
Tx - (transmit)
Rx - (receive)
3
Rx + (receive)
Tx + (transmit)
4, 5
Not used
6
Rx - (receive)
Tx - (transmit)
7, 8
Not used