PLANET GT-90x Series - Manual (Page 15)

2.2.2 Chassis Installation and Rack Mounting
To install the Managed Media Converter in a 10-inch or 19-inch with standard rack, follow the instructions described
below.
Step 1 : Place your Managed Media Converter on a hard flat surface, with the front panel positioned towards your front
side.
Step 2 : Carefully slide in the module until it is fully and firmly fitted into the slot of the chassis.
Figure 2-5 : Insert a Managed Media Converter into an available slot
Step 3 : Attach a rack-mount bracket to each side of the Chassis with supplied screws attached to the package.
Step 4 : After the brackets are attached to the chassis, use suitable screws to securely attach the brackets to the rack, as
shown in Figure 2-6 .
Step 5 : Precede with the steps 4 and steps 5 of session 2.2.1 Stand-alone Installation to connect the network cabling
and supply power to your Chassis.
Caution: You must use the screws supplied with the mounting brackets. Damage caused to the parts by using
incorrect screws would invalidate your warranty.
-10-