PLANET GT-90x Series - Manual (Page 12)

2.1.1 LED Indicators
LED Color Description
PWR Green Lit: When +5VDC power detected.
Lit: To indicate the link through that fiber port is successfully established.
Fiber LNK/ACT Green
Blink: Indicate that the Fiber port is actively sending or receiving data over that port.
Lit: To indicate the link through that port is successfully established.
TP LNK/ACT Green
Blink: Indicate that the port is actively sending or receiving data over that port.
Lit: When the port runs in 1000Mbps Full duplex mode
TP 1000 Green
Off: When the port runs in 10/100Mbps Half / Full duplex mode.
#
Notice:
To press and release the RESET button. The GX-90x will back to the factory default mode. Be
sure that you backup the current configuration of GT-90X; else the entire configuration will be
erased when pressing the “RESET” button.
• Press and release the RESET button shortly, the device will be rebooted.
• Press the RESET button more than 10 seconds, the device will back to the factory default
mode; the entire configuration will be erased.
2.1.2 GT-90X Rear Panel
The rear panel of the Managed Media Converter indicates one DC jack, which accepts input power with 5V DC 2A.
■ GT-90x series
Figure 2-4 Rear Panel of GT-90x
Power Notice:
1. The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the
time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data
loss or network downtime.
2. In some area, installing a surge suppression device may also help to protect your Managed Media Converter from being
damaged by unregulated surge or current to the converter or the power adapter.
-7-