PLANET ICA-3550V - Manual (Page 68)

5 Mega-pixel Outdoor IR PoE IP Camera
ICA-3550V
68
accessing the video from the device over the Internet. The router connects to the Internet over
e blocked from access
ver the Internet. This is
y
the camera must be op
ollow these steps to configure your router’s Virtual Server settings
a series of numbered ports. The ports normally used by the device ar
over the Internet. Therefore, these ports need to be made accessible o
accomplished using the Virtual Server function on the router. The Virtual Server ports used b
ened through the router for remote access to your camera.
F
z
Click Enabled.
z
Enter a unique name for each entry.
z
Select Both under Protocol Type (TCP and UDP)
z
Enter your camera’s
ng the ublic and
local IP address (e.g., 192.168.0.100, for example) in the
default camera port settings, enter 80 into the P
Private IP field.
z
If you are usi
Private Port section
A check mark appearing before
and click Add.
the entry name will indicate that the ports are enabled.
Some ISPs block
open the approp
you will ne
as 808 acc
riate
ed to chan
0. Not all routers are the same, so refer to your user manual for specific
ions on how to open ports.
ess to port 80. Be sure to check with your ISP so that you can
ports accordingly. If your ISP does not pass traffic on port 80,
ge the port the camera uses from 80 to something else, such
instruct
Enter valid ports in the
box Virtual S
on this line to enable setting the device can be accessed from WAN by the router’s
WAN IP address.
By now, you have finish
erver section of your router. Please make sure to check the
s. Then
ed your entire PC configuration for this device.