PLANET FNSW-1602S - Manual (Page 8)

6 7
2.1.3 LED Indicators
LED Color Function
PWR Green Lit: Power on
LNK/ACT Green Lit: indicate the link through that port is successfully
established
Blink: indicate that the switch is actively sending or
receiving data over that port
100 Orange Lit: indicate that the port is operating at 100Mbps.
Off: indicate that the port is operating at 10Mbps.
2.1.4 Extension Slots
The Switch extension slots #17 and #18 can be a 100Base-FX switching port as the
extension module installed.
Please refer to the section 3.2.3.1 Port Configuration for the detailed installation and
settings.
The rear panel of the Switch indicates an AC inlet power socket, which accepts input
power from 100 to 240VAC, 50-60Hz.
2.1.5 FNSW-1602S Rear Panel
Figure 2-2 shows Rear panel of FNSW-1602S.
Figure 2-2 Rear Panel of FNSW-1602S
Power Notice:
1.The device is a power-required device, it means, it will not work till it
is powered. If your networks should active all the time, please consider
using UPS (Uninterrupted Power Supply) for your device. It will prevent
you from network data loss or network downtime.
2.In some area, installing a surge suppression device may also help to
protect your switch from being damaged by unregulated surge or cur-
rent to the Switch or the power adapter.
2.2 Installing a FNSW-1602S
This part describes how to install your FNSW-1602S Smart Fast Ethernet Switch and make
connections to the switch. Please read the following topics and perform the procedures in
the order being pre-sented.
To install your FNSW-1602S on a desktop or shelf, simply complete the following steps.