PLANET FNSW-1602S User Manual

Page 16

Object Description

Enable

Allow user to disable or enable each port. The descriptions of op-
tions are shown as below:
No: disable specific port.
Yes: enable specific port.

Auto

Provide three various negotiation modes. The descriptions of
three various negotiation modes are:
AUTO: auto-negotiation mode
NWAY_FORCE: auto-negotiate to fixed speed and duplex mode.
FORCE: fixed speed and duplex mode.

Spd/Dpx*

Allow user to modify the 4 various speed and duplex mode on
each port of FNSW-1602S. The descriptions of 4 various speed
and duplex mode are shown as below:
10 Half: 10Mbps half-duplex mode.
10 Full: 10Mbps full-duplex mode.
100 Half: 100Mbps half-duplex mode.
100 Full: 100Mbps full-duplex mode.

Flow Control

Provide disable or enable flow control on full-duplex mode and
half-duplex mode. The descriptions of options are shown as
below:
On: enable flow control.
Off: disable flow control.

Table 3-3 Descriptions of the Port Configuration screen Objects

Remark:

1. This option will turned off if set the negotiation mode in “AUTO” mode.

2. The FNSW-1602S’s port#17, #18 can be 100Base-FX switch port. The

100Base-FX module provide half and full-duplex mode selection.

Note: Please configure the 100Base-FX module in the same duplex mode

between the module DIP switch and port #17, #18’s duplex mode
from the console interface. The screen in Figure 3-7 appears. Table
3-4 shows the settings for working under 100Mbps full-duplex mode
and half-duplex mode.