3 aggregator state activity – PLANET FGSW-2620VM User Manual
Page 38
FGSW-2620VM / FGSW-2624SF User’s Manual
4.2.5.3 Aggregator State Activity
When you had setup the LACP aggregator, you can configure port state activity. You can mark or un-mark the port.
Figure 4-2-8 Trunking – State Activity interface
Object
Description
Active
The port automatically sends LACP protocol packets.
Passive
The port does not automatically send LACP protocol packets, and responds only if
it receives LACP protocol packets from the opposite device.
Apply button
Press the button to change the port state activity. Opposite is Passive.
1.
A link having either two active LACP ports or one active port can perform dynamic
LACP trunking.
2.
A link has two passive LACP ports will not perform dynamic LACP trunking because
both ports are waiting for and LACP protocol packet from the opposite device.
3.
If you are active LACP's actor, when you are select trunking port, the active status will
be created automatically.
38