PLANET FGSW-1602RS - Manual (Page 15)

12 13
3.4.1 Port
In this function, user can set up every port’s status
Use I/M/J/L key to move between items
Enabled The port can be set enable or disable mode. If the port sta-
tus is disabled then this port will not receive or transmit any
packet. Default: enable.
Speed
advertisement Set the port link speed and duplex mode base on auto-ne-
gotiation. Default: 100M Full (10/100Mbps port); 1000M Full
(Gigabit port)
Flow Control Enable or disable flow control. Default: Enable
Rx Bandwidth Per port packet transmission control (128K, 256K, 512K, 1M,
2M, 4M, 8M). Default: non-control.
Tx Bandwidth Per port packet transmission control (128K, 256K, 512K, 1M,
2M, 4M, 8M). Default: non-control.
After the port setting, please press “S” to save the configuration. Then press “R” to restart
the Auto-Negotiation to make the setting activated right away.
Be noted, the Switch support auto-negotiation at each port, please remain in option
“100M Full”, “1000M Full” (port#25/26 or port#17/18) if the other device do not support
auto-negotiation. If a device does not support auto-negotiation, the Switch will auto-
detect the optimal speed at half-duplex, i.e. 100Mbps half-duplex or 10Mbps half-duplex.
Also be noted that in Gigabit module both of devices must support auto-negotiation.